Anchorage by Concrete
The Bio-Pure has 4 anti-floatation wedges positioned on the sides. For moderately wet ground these can be covered in a lean mix of concrete to act as an anti-floatation ring. IN SEVERE WET GROUND THE ENTIRE UNIT SHOULD BE BURIED IN CONCRETE UP TO THE INLET AND OUTLETS OR THE ANCHORAGE PIN METHOD SHOULD BE USED.
NB. When using concrete the unit should be filled with water at the same rate as concrete is poured.
High Water Table Anchorage – Dry Pin Method
1. Insert the steel anchorage pins by hammering them horizontally
(90 degrees) to the walls of the excavation into the undisturbed ground at a depth of 1200 mm (from the top). The pins need to be inserted leaving 300 mm protruding into the excavated area.
2. Connect a length of galvanised chain into the hole in the end of each pin using a shackle. Take the loose end to the top of the excavation and secure temporarily.
3. Continue to install tank as per fitting instructions.
4. When Bio-pure is fully installed insert eye bolts into the down position
ie. Eye bolt at the bottom, nut at the top. Attach the loose end of the chain into the eye bolts by means of shackle, adjust and tighten each eye bolt to take up any slack in chain – do not leave any slack in chains as tank may move.
6. Continue to back fill to desired level.
High water table anchorage
4 x 1200mm galvanised steel angle irons (50mm x 50mm x 6mm) each with a point
at one end and a 13mm hole at the other.
8 x galvanised steel ‘D’ shackles.
4 x 1200mm long, 6mm diameter welded link galvanised steel chain.